How to install the drawers of the custom wardrobe?

The wardrobe can be taken out, but it can also be installed. There are several installation steps and processes that need to be discussed with you. How to operate it so that the installation can be more secure and worry-free. The following is the detailed assembly process. Sometimes I especially want to customize a wardrobe, but I don't know how to do it, and doing it myself will waste time and energy. So, here I will tell you how to do it.

Point the floor with a mat, first assemble it from the wide side panel at one end of the wall, and place the wide side panel flat on the air (700mm away from the back wall). First, place the filled three-in-one rubber plug plate on the pad, check that the hole spacing is consistent with the drawing, and install the three-in-one single connecting rod. Then nail the solid layer to the wooden plug and fix it under the wide side plate, the large handle hole of the top plate is facing up, the other solid layers are facing down, and the large handle hole of the foot line is facing inward (the two solid layers are the same height as the L frame, that is, the bottom plate to the solid layer The inner space is 960mm, and the laminate hole is punched on site). Put on the side board, nail on the cork, the cork needs to connect the solid layer on both sides. Install the double link under the second cabinet solid layer. Note that the large handle under the double link can only be locked halfway, that is, 90°. When the two solid layers are fixed with the side plate, then tighten the large handle at the same time. Repeat the installation steps for the second cabinet when installing the third cabinet.

Nail back plate. Place the side of the assembled custom cabinet under the floor where the pad has been padded, and flatten the side panel to form the same three-dimensional. Use a ruler to measure the diagonal dimensions of the cabinet, adjust them to be equal, and install the first backboard from the wide measuring board. Note that if there are solid nails on both ends, first use a pencil to draw the center line of the solid layer, and then nail it. nail.

Installation of L-frame. Use the side plate of the L frame to draw a parallel line under the corresponding side plate, and then move up 9mm to draw the center line of the three-in-one rubber granule, and use the top class of the L frame to draw a parallel line under the corresponding bottom plate, within the flat line Into 9mm draw the center line of three one-gel particles. Use a 10mm drill to make a hole with a depth of 10-20mm. Install the single lever. After the L frame is installed, add nails to the back panel to fix it.

Clear the sundries at the installation position of the wardrobe, stand with one person on the left and right, tilt the wardrobe back slightly, lift it hard, and move it back to the desired position, taking care not to scratch the floor and wall.